RANS Vs DES Drag Optimisation on a Toyota Yaris

Drag optimisation

  • Design optimisation is a challenge well-suited to CFD. The effect of changes to the model can be parameterised and tested without the need to large amounts of manufacture and physical testing.
  • A large number of parameters can be investigated. However, it is still difficult to do this efficiently and effectively. Typically 6 independent shape change parameters are used by TotalSim for most short-timescale work.
  • DES is also a considerable challenge to run for real-world cases with current hardware, but it is becoming increasingly necessary to obtain sufficiently accurate modelling of the flow.
  • Here multi-parameter optimisation is used together with DES to demonstrate the differences between a RANS optimum and a DES optimum.
    • A modified OpenFOAM® ** solver using the SST k-omega turbulence model provides the RANS solution.
      • The RANS case was run for 3000 iterations, with averaging done over the last 500 iterations.
    • The DES was run using the SpalartAllmarasDDES turbulence model and adaptive time-stepping within the pimpleFOAM solver. The solution was started from the converged RANS solution
      • The DES case was run for 1 second, with averaging done over the last cycle of 0.5 seconds.

Optimisation Parameters

  • Here at TotalSim we use Sculptor™ to define the model shape change parameters, in this case it applies shape changes to:
        1. Roof Slope
        2. Front Screeen
        3. A pillars
        4. Rear Screen

Optimisation Design Parameter for CFD Drag reduction study by TotalSim

Response Surface Methods

  • Using a response surface is a substitute for using resources on many CFD runs
  • Inputs are the results from the design of experiments that are run through CFD.
  • It gives a quick answer and can give an indication of what parts of the DOE are sparse and need further refining.
  • Generally this is done for the are that is of interest – in this case it is a low drag vehicle with the greatest internal cabin volume.

TotalSim Optimisation Process


RANS and DES Optimisation response surfaces as run by TotalSim using OpenFoam and Sculptor

RANS process gives a peak drag reduction of 1.0% compared to a DES peak of 2.8%.

TotalSIm Comparison of RANS and DES results trade off between drag and cabin volume for Toyota Yaris model optimised in CFD using OpenFoam

Comparing the RANS and DES optimisations suggests there could be a common design that performs well in both modelling approaches.

TotalSim Comparative drag space for RANS and DES as optimised in CFD with OpenFoam

RANS Optimised results – Cp

The pressure at the base of the windscreen is reduced in the optimised case

RANS Optimised Results - Cp as run by TotalSim and sovled with OpenFoam

Optimised results – Wheel wake velocities

Optimised results - wheel wake velocities run by TotalSim and sovled with OpenFoam

Conclusions

  • The optimisation process works well with RANS-derived data, finding a 1% reduction in drag.
  • The roof slope is the most dominant parameter in the study, further drag reductions could be found by replacing the insensitive parameters.
  • The DES approach requires significantly more run-time to gather statistical information resulting in a 500% increase in computing time over the RANS method. The DES solutions reported lower drag than the RANS for each run, most likely due to the separation point on the front wheels.
  • Reducing drag in both RANS and DES is possible and does not need to compromise the overall cabin volume; however the region of maximum drag in the design space is different for each method.
  • DES can be used for optimisation but involves greater levels of uncertainty than RANS.

 

**OpenFOAM® and  OpenCFD® are registered trade marks of ESI.

**This offering is not approved or endorsed by OpenCFD Limited, the producer of the OpenFOAM software.